by wavefin » Mon Dec 19, 2011 11:19 am
by jaffa1949 » Mon Dec 19, 2011 12:14 pm
by Roy Stewart » Mon Dec 19, 2011 8:35 pm
by Roy Stewart » Mon Dec 19, 2011 8:39 pm
by drowningbitbybit » Mon Dec 19, 2011 9:05 pm
by wavefin » Fri Dec 23, 2011 3:56 am
by wavefin » Sun Dec 25, 2011 11:56 pm
“All surfboard fins” create drag and friction.Roy_Stewart wrote:The main issue with that setup is that the wings will prevent the board from rolling fron rail to rail, a secondary issue is that there are two unnecessary dragt inducing fin tips, the job could be accomplished with two rather than four.
If the fins are swapped so that the wings point inwards there will be some improvement.
by wavefin » Mon Dec 26, 2011 12:21 am
drowningbitbybit wrote:Are they like bicycle stabilisers for surfboards?
by wavefin » Mon Dec 26, 2011 1:37 am
Roy_Stewart wrote:Another problem is that the wing area is much too far from the bottom of the board, it should be within three inches or so of the bottom of the board otherwise the handling problems will be drastically increased at speed.
8 hours ago by oldmansurfer6 comments
2 days ago by LoserKid3 comments
2 days ago by jaffa194911 comments
2 days ago by AKLsurfer3 comments
2 days ago by TheFNG2 comments
3 days ago by jaffa19493 comments
3 days ago by NEWYORKCITYSURF2 comments
3 days ago by mrlegion19832 comments