Quick question on loose fin!
2 posts
• Page 1 of 1
Quick question on loose fin!
by asw222 » Fri Aug 05, 2011 7:00 pm
I got an M5 fcs fin set today and the left fin is loose in the like upper most hole. I screwed it in but theres about a cm of space in there. Is this alright, will it fall out or anything? Can I add some resin and sand it to thicken it up and fit in the hole?
- asw222
- New Member
- Posts: 14
- Joined: Thu Aug 04, 2011 12:00 am
Re: Quick question on loose fin!
by jaffa1949 » Sat Aug 06, 2011 12:53 am
Try a little duct tape in the front tab where the gap is. Resin and sanding works too.
I've taken up troll hunting just for fun, instead of a rifle I'll just use a pun!
-
jaffa1949 - Surfing Legend
- Posts: 2279
- Joined: Thu Jul 08, 2010 12:01 am
- Location: South south New South Wales
2 posts
• Page 1 of 1
Similar topics
| Quick question of board choice RELATED: Surf Chat Author: still-learning Replies: 22 |
Ding repair question RELATED: Surfing Hardware Author: metrosurf13 Replies: 7 |
Phil Byrne, 7,2" board question. RELATED: Surfing Hardware Author: Roystar Replies: 1 |
etiquette question - was I in the wrong? RELATED: Longboarders Only Author: AaronW Replies: 13 |
Graphics Question RELATED: Shoredump Author: Callum_Stephenson10 Replies: 6 |