by Jack2007 » Tue Apr 20, 2010 8:49 pm
by kitesurfer » Wed Apr 21, 2010 7:02 am
by Jack2007 » Thu Apr 22, 2010 11:55 am
by kitesurfer » Thu Apr 22, 2010 1:01 pm
Jack2007 wrote:KS thanks for the reply.
If I needed to do a larger design or even a full board spray, what would you recommend apart from a compressor/airbrush?
Also, as its acrylic is plain water the best way to thin it? I will be doing extensive practice tests first but its good to know beforehand.
by billie_morini » Sat Apr 24, 2010 6:42 am
by Lorniaj » Mon Aug 09, 2010 2:43 pm
by ag1981 » Tue Aug 23, 2011 3:15 pm
Lorniaj wrote:Hi there, A friend painted theirs once.
They first of all primed the board with a primer, sorry I can't remember what type, but I just know they primed it first, I'm pretty sure they got hold of this from a DIY store. They then spray painted the design on using Montana Spray Paint, they got this from http://www.artyfect.com.
It worked a treat! It wasn't difficult either!
I'm very tempted to do it myself but I haven't decided on a design yet.
by esonscar » Tue Aug 30, 2011 11:29 pm
by julia2011 » Fri Dec 30, 2011 7:05 pm
by jaffa1949 » Sat Dec 31, 2011 4:24 am
4 minutes ago by gideonkyle3 comments
4 hours ago by ngreene5 comments
8 hours ago by mitchmitchelson11 comments
15 hours ago by surfero933 comments
21 hours ago by jaffa194912 comments
2 days ago by oldmansurfer6 comments
3 days ago by LoserKid3 comments
3 days ago by AKLsurfer3 comments