by Mirx » Sun Dec 28, 2008 7:48 pm
I bought an Xcel Infinity 5mm X-Zip and had a list of problems. Here they are:
1. - The edge on the left side of the neck ripped after the 3rd session. Glued it up with Blackwitch - lasts a month or so and then I have to do it again.
2. - Same on the right side after the 10th session.
3. - Both the left and right Knee Panels ripped off coming away from the neoprene. Again, ongoing Blackwitch treatment.
4. - Inside, in between the legs area, the Fusion Seal tape came off allowing water to enter the wetsuit. Had to cut the bit off and reseal it with a new neoprene tape and just over one tube of Blackwitch.
5. - The seam at the bottom left leg split across the Fusion Seal tape and yes, good trusty Blackwitch once again! This one kept ripping so I just cut an inch off the length of the left leg.
The suit was carefully chosen regarding the size so the fit is not to blame ( Medium suit for a 5'10" (179cm) and 11st (70kg) guy. )
What did not help the matter is the fact that here in the UK there appears to be only one location available to repair the Xcel wetsuits under warranty and it takes around 3 weeks!
I am very disappointed after all the hype, but hey, perhaps I was unlucky to get a baddun!
On a positive side, the suit is wonderfully warm and impressively flexible.
I am only using it when the surf gets below 10 degrees C , otherwise a Psycho 2 which is considerably superior in quality.
.